![]() Unless directed otherwise, get the car warmed up first. Then hold the car at 1500 RPM for 15 seconds, 2000 RPM for 15 seconds, 2500 RPM for 15 seconds and 3000 RPM for 15 seconds. Start the car and log idle for 30 seconds. Unless directed otherwise, get the car warmed up first, start the logger, log for 3 minutes and save the log. Be sure to select "Save All" and NOT "Save View"ġ2) Be sure to remember where you save the file so it's easy to find later. If you need a configuration file for your vehicle, please email Once the Config file loads, click on the green button to start loggingġ0) When you are ready to stop logging, click the Red button to stop.ġ1) To Save your datalog, Click "Save" under the Datalog section. Attached at the botom of this page are some common configuration files. We recommend downloading SCT's newest datalogging software, LiveLink GenII from the SCT website here:ġ) Install Livelink GenII on your computerĢ) Run Livelink GenII and select "I want to datalog a vehicle"ģ) Connect your SCT device to your computer with the USB cableĤ) Connect your SCT device to the Vehicles OBD-II (Diagnostic) Portħ) Once it recognizes the vehicle as show below the "Check Communcation" button, select "Load Config"Ĩ) Select the Config.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |